|
| LinkBack | Thread Tools | Display Modes |
09-21-2012, 06:57 AM | #1 |
Quarry Creeper Join Date: Feb 2012 Location: Canada
Posts: 458
| Need help figuring this out
Axial AE2 ESC no response from the radio. It gets power, servo is OK but when I blip the throttle on the radio nothing happens. I do however see lights flash on the ESC Fresh batteries are on. |
Sponsored Links | |
09-21-2012, 07:15 AM | #2 |
I wanna be Dave Join Date: May 2011 Location: Lost in Oregon
Posts: 4,450
| Re: Need help figuring this out
Re-bind time....
|
09-21-2012, 09:26 AM | #3 |
Quarry Creeper Join Date: Feb 2012 Location: Canada
Posts: 458
| Re: Need help figuring this out
You mean rebind the radio with the receiver? I did that already
|
09-21-2012, 10:03 AM | #4 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Re: Need help figuring this out
Calibrate the ESC to the Radio, I assume that it is not initializing properly because the signal is out of range. Does it beep when you turn it on? |
09-21-2012, 10:13 AM | #5 |
Quarry Creeper Join Date: Feb 2012 Location: Canada
Posts: 458
| Re: Need help figuring this out Last edited by natskiboy; 09-21-2012 at 10:17 AM. |
09-21-2012, 04:21 PM | #6 |
Quarry Creeper Join Date: Feb 2012 Location: Canada
Posts: 458
| Re: Need help figuring this out |
09-21-2012, 06:00 PM | #7 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Re: Need help figuring this out
I will send you my PP addy haha
|
09-21-2012, 07:46 PM | #8 |
Quarry Creeper Join Date: Feb 2012 Location: Canada
Posts: 458
| Re: Need help figuring this out
I knew it was something simple but didnt know how to calibrate the Axial AE2. Some ESC's have buttons on them.. lol Thanks again for the lead |
09-21-2012, 09:30 PM | #9 |
I wanna be Dave Join Date: May 2011 Location: Lost in Oregon
Posts: 4,450
| Re: Need help figuring this out |
Need help figuring this out - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I need help figuring out which crawler i should get!!!! | peck126 | Newbie General | 5 | 03-04-2012 08:57 AM |
figuring my bills | slobin3d | Chit Chat | 22 | 12-20-2009 11:32 PM |
Need Help Figuring Out Servo Strength? | Shaun | Electronics | 0 | 08-10-2008 03:34 PM |
Figuring out how to embed videos | _BEN_ | Comments, Suggestions, and Help | 11 | 04-12-2008 10:29 PM |
Figuring out the pitch | cheapjeep2 | General Crawlers | 5 | 07-13-2005 10:36 AM |
| |