| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
08-14-2013, 08:35 AM
| #1 |
| RCC Addict Join Date: Jan 2011 Location: Razorback Haven
Posts: 1,620
|  Brushless waterproofing?
Ok I tried asking this in the waterproofing section and got no responce! I have a 10.5 brushless trinity to run in my wraith, I have purchased some corrosion X to dip the electric components in. All the waterproofed brushless I have seen have a sealed can. My can has vent holes built in, is this going to be a problem, or after I dip everything in corrosionx am I good to go?
|
|  |
| Sponsored Links | |
| | |
|
Brushless waterproofing? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The best way of waterproofing! | TnT817 | Tools, and Procedures | 0 | 02-28-2013 06:56 PM |
| Waterproofing a brushless motor | jthellfire911 | General Scale Talk | 2 | 01-15-2013 07:57 PM |
| waterproofing brushless? | nuggsmoker | Electronics | 2 | 02-07-2012 03:15 PM |
| waterproofing | motostowes | Newbie General | 3 | 08-17-2010 12:21 AM |
| waterproofing lipo and brushless? | badhoopty | Electronics | 5 | 04-09-2008 02:21 AM |
| |
Linear Mode
