10-22-2010, 09:31 AM | #1 |
Rock Crawler Join Date: Jan 2010 Location: SOUTH CRAWLINA
Posts: 947
| slw hub???
I've tried searching but could not find what I need, so if it has been posted already I'm sorry. So I've went with slw's 1'' on the front of my berg. Now the 8mm socket I have been using don't fit in the hub, is there a thin wall nutdriver or socket out there I can get? Thanks!
|
Sponsored Links | |
10-22-2010, 09:58 AM | #2 | |
Rock Crawler Join Date: Jul 2008 Location: Chula Vista
Posts: 971
| Quote:
I actually just grinded mine down but I think the Dynamite hex driver works. | |
10-22-2010, 09:58 AM | #3 |
I wanna be Dave Join Date: May 2009 Location: Tehachapi,Ca
Posts: 2,334
|
I used a dremel and just ground the outside of the wrench it has a little taper to it it works just fine even being really thin at the end
|
10-22-2010, 10:15 AM | #4 |
Rock Crawler Join Date: Oct 2008 Location: Somewhere near the lake in IL
Posts: 975
|
Go to ace or whatever buy a cheaper nut driver and grind it down that will fit for sure I think I picked one up for like 3.99
|
10-22-2010, 10:15 AM | #5 |
Rock Crawler Join Date: May 2009 Location: Calgary
Posts: 911
|
I believe that the O'Donnell tools have a thin enough wall to get in there. |
10-22-2010, 10:41 AM | #6 |
Rock Crawler Join Date: Dec 2007 Location: T1E Country
Posts: 692
|
I use a Craftsmen 4-1 screwdriver. Just remove the tip from shaft and it fits very well. I know ALOT of guys just grind down what they need though. |
10-22-2010, 10:56 AM | #7 |
Rock Crawler Join Date: Jan 2010 Location: SOUTH CRAWLINA
Posts: 947
|
Thank's guy's for all the very helpful info. |
10-22-2010, 11:22 AM | #8 |
RCC Addict Join Date: May 2009 Location: In the warmth!
Posts: 1,163
|
I just bored out the hub just enough to use whatever wrench I wanted. Be careful... |
10-22-2010, 08:40 PM | #9 |
RCC Addict Join Date: Jul 2009 Location: AT THE DRAGON'S LAIR
Posts: 1,319
|
O'Donell X2!
|
10-23-2010, 10:11 AM | #10 |
Rock Crawler Join Date: Dec 2008 Location: Displacement
Posts: 525
|
The craftsman 7mm nut driver, part# 41983, fits without grinding anything either.
Last edited by 8-454; 10-23-2010 at 10:27 AM. |
| |