| |
01-13-2020, 10:41 AM
| #1 |
| Quarry Creeper Join Date: May 2010 Location: ny
Posts: 466
|  R1 question
I'm getting a R1 on trade and it has a 55t motor Has anyone put a holmes 15t trailmaster in theirs? .. I want wheel speed It'll be a mud / basher rig  Sent from my SM-G965U using Tapatalk |
|  |
| Sponsored Links | |
| | |
|
03-03-2020, 03:55 PM
| #2 |
| Newbie Join Date: Apr 2019 Location: Molalla
Posts: 47
| Re: R1 question
I have a 35t in mine. Not too much wheel speed. But be warned. There is no slipper clutch and the gears are all plastic. I haven't found any all-metal replacements. |
|
| |
|
04-06-2020, 12:34 PM
| #3 |
| I wanna be Dave Join Date: Jun 2016 Location: Deep in the Everglades
Posts: 5,818
| Re: R1 question
I ran a Tekin 17.5 on 3s I also ran tall tires(Ruptures J Concepts) had lots of speed, no issue with the trans gears at all. It ate portal bearings routinely and drive shaft cups exploded more than once, due to extreme angles |
|
| |
|
04-06-2020, 11:34 PM
| #4 | |
| RCC Addict Join Date: Feb 2016 Location: Santa Maria, CA
Posts: 1,751
| Re: R1 question Quote:
I didn't have any problems with the plastic tranny gears either , but if you really want steel gears, they're out there (or, at least they used to be): https://www.ebay.com/itm/Gmade-Komod...-/264268867899 | |
|
| |
 |
R1 question - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mmp question and cc bec question. | Cchapman | Electronics | 6 | 12-24-2014 04:38 PM |
| Tire foam question. WARNING!!! Noob question! | tokdl | Tires and Wheels | 6 | 05-07-2014 10:55 AM |
| Drive way too fast question and front locker question. | Mr.JayDeeM | Axial AX-10 Scorpion | 15 | 02-07-2012 09:19 AM |
| clearance question and articulation question | axialnut | Newbie General | 17 | 09-24-2010 09:55 PM |
| Simplefied question for pervious question. | Mudsy | Tamiya Clod Buster | 2 | 05-03-2009 09:59 AM |
| |
Linear Mode
