| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
10-17-2005, 04:40 AM
| #1 |
| Newbie Join Date: Oct 2005 Location: AUSTRALIA
Posts: 1
|  new crawler using LST axles
Hi There, I have purchased a pair of LST axles and diffs etc. I was hoping to build 2 custom gearboxes and use 1 lathe motor on each axle like a custom clod set up. I need help selecting an overall drive ratio suitable for crawling, any ideas where I can get gears/gearboxes from? i hope to mount the motor over the axle for maximum ramp over, any help on this would be greatly appreciated.
|
|  |
| Sponsored Links | |
| | |
|
10-17-2005, 02:09 PM
| #2 |
| Rock Crawler Join Date: Apr 2004 Location: Not where I belong.
Posts: 964
|
ive seen it done with a maxx. someone had a pede tranny attatched right to the axle and a motor mounted to that, but thats all i can remember.
|
|
| |
|
10-17-2005, 03:13 PM
| #3 | |
| Rock Crawler Join Date: Jun 2004 Location: SW, Connecticut
Posts: 685
| Quote:
time to post it up | |
|
| |
|
| |
Linear Mode
