| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
05-07-2020, 05:28 PM
| #1 |
| Newbie Join Date: Apr 2020 Location: Johnstown
Posts: 14
|  Traction Hobbies Founder 2 Build
about a week ago i got my founder 2. since then, i have finished the body on it and upgraded the motor to a hobbywing axe 550 system. in the three runs i did so far, i stripped out the original plastic servo horn along with the one i had on my slash. im currently dead in the water as i dont have any spares, so said screw it and went hog wild on the steering setup. i ordered a stockpile of aluminum steering horns along with a Savox SB-2290sg and 14amp castle bec with castle link to power it at 8.4V to get the full 902oz-in out of it!      and comparing it to my 1:1   Last edited by Trevinator1990; 05-08-2020 at 04:35 AM. |
|  |
| Sponsored Links | |
| | |
|
Traction Hobbies Founder 2 Build - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Traction Hobby Founder 2 | Frank211 | General Scale Talk | 3 | 09-30-2019 04:11 PM |
| Traction hobby founder | truemetalfpv | Scale Videos! | 0 | 09-30-2019 04:05 PM |
| “The Inside Soup” with Heath Meschkow, President & Founder of CowRC - by RC Soup | Team CowRC | Non Crawler RC's | 0 | 12-07-2013 09:28 PM |
| Evergreen Founder Dies | TexasSP | Chit Chat | 0 | 07-07-2010 01:53 PM |
| BMI Hobbies Crawler Build | DeSiRe@BMI | Tamiya Clod Buster | 17 | 04-05-2008 06:26 PM |
| |
Linear Mode
