AR60 multi axle rigs?

[wraith878]

Sent from my HTC One M9 using Tapatalk

[johnnyh66]

Here's the one I was building before the pass through diff... it's on hold.
It uses 2 transfer cases.

[HahnsB2]

Originally Posted by wraith878

Sent from my HTC One M9 using Tapatalk

Why is the rear axle swapped sides? You know you can just swap the ring gear to the other side inside the diff, right?

[wraith878]

Hah, no never crossed my mind wow thanks

Sent from my HTC One M9 using Tapatalk

[Szczerba]

Originally Posted by wraith878

Hah, no never crossed my mind wow thanks

Sent from my HTC One M9 using Tapatalk

Yup, as you have it shown, flip the whole axle, then put your truss and everything back on top, then flip the ring gear/locker. Good to go! And to double check, just make sure the rotation is correct before snugging it all back up.

[blarouche]

Originally Posted by wraith878

Hah, no never crossed my mind wow thanks

Sent from my HTC One M9 using Tapatalk

Its funny after I saw your pick I panicked I'm building a ar60 6x6 as well,a d flipped the ring gear. I didn't even test it and panicked it was not going to work.

Nice metal work on the body.

[wraith878]

Originally Posted by blarouche

Its funny after I saw your pick I panicked I'm building a ar60 6x6 as well,a d flipped the ring gear. I didn't even test it and panicked it was not going to work.

Nice metal work on the body.

Thank you, frame is all 6061 and the body is all 3003 aluminum .050 as it sits electronics and battery somewhere around 8-9 pounds


Got ring gear flipped everything back together works much better, flexs more driveshaft doesn't fall apart when it flexs anymore. Hard to believe I never thought of that earlier, glad I posted on here


Sent from my HTC One M9 using Tapatalk