|
| LinkBack | Thread Tools | Display Modes |
09-07-2015, 05:19 PM | #1 |
Rock Stacker Join Date: Jan 2015 Location: Columbia
Posts: 54
| Axial HD gear install help!!!
So after installing my HD gears in the front and rear of my G6, the front seems to be binding a bit. I know you can shim these. But what I don't understand is knowing the amount of shims. I guess it's trial and error. I do know if you push the pinion gear to far in, it seems to bind (no not the one on the motor. I'm speaking of the ring and pinion gears) but to far out it does the same. So help me out. What has worked for you and what brand shims did you use. Thanks guys and gals. |
Sponsored Links | |
09-07-2015, 06:09 PM | #2 |
I wanna be Dave Join Date: Jul 2013 Location: Minneapolis
Posts: 5,202
| Re: Axial HD gear install help!!!
traxxas 1985 shims. But if its binding when you pull the pinion shaft out then there is something more wrong. Maybe you over tightened the screws on your axle housing?
|
12-26-2015, 10:19 PM | #3 |
Rock Stacker Join Date: Jan 2015 Location: Columbia
Posts: 54
| Re: Axial HD gear install help!!!
Maybe, this thing has had issues with the front of it from out of the box. I build the rear the same and nothing.
|
12-26-2015, 10:27 PM | #4 |
RCC Addict Join Date: Oct 2011 Location: British Columbia
Posts: 1,487
| Re: Axial HD gear install help!!!
If you're using the stock locker, it needs the little paper gasket. If you're using aftermarket lockers, no gasket is needed. One (or two) 1985 shims between the pinion output and the driveshaft will help keep the pinion snug against the inside bearing. |
12-27-2015, 04:40 PM | #5 |
I wanna be Dave Join Date: Jun 2013 Location: Ramona, CA
Posts: 2,178
| Re: Axial HD gear install help!!!
I'm sure the above two experienced posters will get you squared away without a doubt. With a new axle set up i check to make sure all is good after a few baby runs before i lightly beat on it. I just drive so no comps or goofball attempts at a line i know i can't do. I did not like the Traxxas 1985 Teflon shims after a few runs so i switched to metal shims and i will use these from now on. Just my .02 X-Mas bonus. Team Durango 5x8x0.5mm Idler Gear Shim Set (10) [TDR709033] | Parts - AMain Performance Hobbies - AMain Performance Hobbies. |
Axial HD gear install help!!! - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can't install pinion gear on RC4WD motor? | Bully2RockRomper | Newbie General | 0 | 02-26-2015 09:25 PM |
Driveshaft and gear install | PSSUPERSTORE | Axial SCX-10 | 2 | 09-25-2013 06:42 PM |
AX30401 Install Help! Gear shaft sticks out further than stock | jhonchua | Axial SCX-10 | 4 | 07-24-2012 08:15 AM |
Motor Install Gear Mesh??? | skullking | Venom Creeper | 9 | 02-09-2010 01:48 PM |
Spur gear adaptor for Pede install ?? | Gabe | Newbie General | 13 | 03-26-2006 01:42 AM |
| |