exo crawler?

[jthellfire911]

How Do you think the exo would do with the 3300kv pro4 and mmp, 2.2 wheels tires, traxxas big bores f/r upgraded r/c/r diffs and motor mount do as a go fast if/rs crawling rig? thanks.

[frdtrkguy]

Check out my build thread in my sig..

[jthellfire911]

Originally Posted by frdtrkguy

Check out my build thread in my sig..

I've actually read it. Just curious if the exo without doing a trans Swap would still be crawlable with the pro4 3300 kv setup.

[frdtrkguy]

If you geared it as low as possible it may be ok. I never tried it without the trans..

[Szczerba]

14/56 gearing crawls great. With plenty of wheel speed to get it. Exo-Wraith but same gear ratios in axles.

MMP with Pro4 3300 on 11.1v.

Szczerb'a Wraith Build, of sorts

....

[jthellfire911]

Originally Posted by Szczerba

14/56 gearing crawls great. With plenty of wheel speed to get it. Exo-Wraith but same gear ratios in axles.

MMP with Pro4 3300 on 11.1v.

Szczerb'a Wraith Build, of sorts

....

Do you know a part # for a spur gear that will mount to the exo trans?

[frdtrkguy]

Originally Posted by Szczerba

14/56 gearing crawls great. With plenty of wheel speed to get it. Exo-Wraith but same gear ratios in axles.

MMP with Pro4 3300 on 11.1v.

Szczerb'a Wraith Build, of sorts

....

But your rig, like mine, uses a transmission. Which adds like 2.7:1 to the overall ratio.. I think the OP is asking about gearing the stock direct center drive exo for crawling.