09-17-2011, 08:53 AM | #1 |
Rock Crawler Join Date: May 2011 Location: SoCal
Posts: 949
| Greased Lightening
I'm trying to remove factory anodize from beadlock rings and my results are a bit different from what I've seen posted. I had previously painted these, outside surface only, and the first thing I discovered is GL didn't affect the paint. But a few seconds in acetone made short work of the paint. Then back into GL. An hour later only the back surfaces had lightened. Eventually I gave up after 2-hrs and rinsed them off for the night. This morning I started again with fresh GL and it's foaming up pretty good, so I think it's working. But at some point I'll just polish them up manually with a Dremel or something. Lessons learned? GL isn't a paint remover, and it "wears out" so needs replacement throughout the process. And in my case takes a lot longer than some others lead me to believe. Anyone see it diffrently? |
Sponsored Links | |
09-17-2011, 11:36 AM | #2 |
RCC Addict Join Date: Dec 2006 Location: Oak Ridge, TN
Posts: 1,141
|
I had about the same experience with gl as you. Most posts I had seen said 30min and your ready to polish. After a couple hours and several changes I still had to hit the parts with sand paper to get them ready to polish. The gl did 90% of the work so still a success in my book.
|
09-17-2011, 11:40 AM | #3 |
Rock Crawler Join Date: May 2011 Location: SoCal
Posts: 949
|
Yeah, I just finished the job. A grinder-mounted wire wheel made short work of what was left. Replacing the fluid multiple times is a big deal. Fresh fluid foams up like crazy. A few minutes and it's spent. Long soaks in old fluid are a waste of time.
|
09-18-2011, 02:47 PM | #4 |
Quarry Creeper Join Date: Oct 2010 Location: NOR-CAL
Posts: 382
|
I use the yellow can of Oven Off.Works really good then polish the parts with Mothers aluminum polish. |
| |