Increased "Caster" Cs

[KC_JoNeS]

Originally Posted by akguanja

If your not trying to install bearings for your knuckle screws or if the tabs are not off by that much I don't think it will be an issue but if you plan on putting bearings in your C's you will definitely need to straighten the tabs out to a true 90 off the C otherwise your screws will not matchup with the knuckle correctly.

For those who are not planing on putting bearings in these the hole in the tabs are big enough that even with them being out of a true 90 it shouldn't matter much other then a little uneven wear on the heads of your screws and or possibly being a little tight until they wear in

Thanks for the clarification Tre.

[dezmoon]

got mine in,,thanks so much,,,

[Redronin]

Got mine and did as you said and put them in the vice and they look awesome! I'll post pics of my build later look for it!

[gyrene]

Recieved my first set over the weekend. They look great. Looks like i'll have to put them in a vise as well, but no biggy. I should have my 2nd set soon.

[Ace138]

For guys running the Jones Cs, what are you using for kingpins? I'm running stock plastic kingpins and have a lot of slop. I had to use brass bushings for spacers but need to find a better solution.



Thanks Jones for making them, one less thing to worry about breaking!!

[CrewCab59]

Originally Posted by KC_JoNeS

Thanks alot mate!

Casey

Just got them in today , alot stronger than the others I have

Thanks

[Redronin]

Originally Posted by Ace138

For guys running the Jones Cs, what are you using for kingpins? I'm running stock plastic kingpins and have a lot of slop. I had to use brass bushings for spacers but need to find a better solution.



Thanks Jones for making them, one less thing to worry about breaking!!

For mine I used 3mm allen head screw with the cap head. This is the big bulky one that has a square side profile. Most are a little bit larger than the hole. To fisx this I chucked the screw in my drill press and sanded it down a little with a file. If you don't have a press you can use a drill all the same, as long as it spins.

[squatch71]

Are these still around?? would take a set.

[KC_JoNeS]

I still have a bunch of these.

Casey

[TURBOFEST]

Pretty sure I'm gonna snag a pair next paycheck.

[saniel68]

Pulled the trigger on a pair!

[canadianlimited]

Hey there Mr Jones
do you still have a set of these. i finally gots some money in the ole pp

[huyrua]

Looking for two sets also.

[huyrua]

Nevermind, found uout how to order here

http://www.rccrawler.com/forum/axles...ess-steel.html

[ZoSo]

RCP Crawlers has KC Jones C's in stock

KC*Jones*TLT*Clocked...