Need More Torque! Tekin 21.5 on 3S Lipo

[Randy P]

Awesome, there are always solutions to problems if you look for them. I will keep answering the questions that come up.

[Csnyder]

Originally Posted by Vertec

I ran into a guy at a lhs that was have a speed and binding issue awhile back. He was having a hard time even getting it to drive up on a wall. We started looking at gears and all when i noticed that the hubs he was using where a tad deeper where the pin fit and was letting the hub bind with the axle.So maybe a bent axle pin? Im sure this might be something you done checked but thought i would throw it out there anyways. Hope you can get it figured out

I didn't notice any bent pins a few weeks ago, but then again it's possible that I may have overlooked something. Thanks for the suggestion.

If all goes well I will be going through my rig top to bottom again in a week or two anyway, and I'll keep an eye out for the pins when I do. The wife asked me for a Christmas list, so I gave her a list of RC part numbers.

- Chris

[Csnyder]

Originally Posted by Randy P

Awesome, there are always solutions to problems if you look for them. I will keep answering the questions that come up.

Is there any more info you're able to share about the Roc 412 motors? Any sort of ballpark ETA for when they'll be available to the public?

- Chris

[Randy P]

I can't give out eta dates just yet. We're still tweaking on the design a bit. I hope to have more feedback from Scott Hughers and Bender from Axial shortly.

[untchabl]

Any of you guys gotten more improvements out of the Tekin setup? Got a Tekin RS and a 13.5 Redline motor in the mail for my LNC and want to get it ready for a comp next weekend.

[killswitch]

Update it to the newest software as soon as you get it. The new min drive value is really nice. I'll dig my hotwire out tomorrow and post up the setup I'm running at the moment for a 17.5 Epic motor.