| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-16-2013, 02:18 PM
| #1 |
| RCC Addict Join Date: Jun 2006 Location: Durham, NC, USA
Posts: 1,164
|  I now have 6 MIP Thorp hex hand tools
I have built several RC kits before and I only used the L hex wrenches from the hardware store. I would be able to complete the kit builds, but my fingers would hurt after a while. Now, I have invested a little bit of money to buy the proper tools, since I have 3 kits that are waiting for me to start and finish. I have one TLR 22SCT kit and two TLR Ten-SCTE 2.0 kits. I will certainly enjoy the builds better, using my brand new MIP Thorp hex wrenches. I only have six of them thus far, but I don't usually use the other sizes. I bought the 1.5mm, 2.0mm, 2.5mm, .050, 1/16", and 5/64".  |
|  |
| Sponsored Links | |
| | |
|
03-22-2013, 05:49 PM
| #2 |
| Rock Stacker Join Date: Feb 2013 Location: Sydney
Posts: 69
|
yes the MIP drivers are really nice. the only small downside is I wish they had clearer size markings, but that's a small nitpick. I think once you've used a proper hex driver you'll never want to go back to those L hexes  |
|
| |
|
03-22-2013, 07:21 PM
| #3 |
| Pebble Pounder Join Date: Dec 2011 Location: riding the rails
Posts: 132
| Re: I now have 6 MIP Thorp hex hand tools
I know I love my mip drivers, I won't use anything else.
|
|
| |
|
I now have 6 MIP Thorp hex hand tools - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cutting Delrin with hand tools? | BigB_117 | Tools, and Procedures | 13 | 04-22-2011 11:22 PM |
| Quality Hand Tools | joesbruiser | Chit Chat | 28 | 05-12-2010 05:30 PM |
| Rate your tools!!! looking for a new hex driver set | peej410 | Tools, and Procedures | 30 | 09-07-2006 10:12 PM |
| |
Linear Mode
