| |
10-04-2008, 03:52 PM
| #1 |
| Rock Stacker Join Date: Sep 2007 Location: york, SC
Posts: 73
|  drive shafts
ok im building a maxx crawler and i need some drive shafts. stock 3.3 tmaxx shafts are to short( the long ones). is there a way to modify them to make them longer or how do i make my own shafts? daleo |
|  |
| Sponsored Links | |
| | |
|
10-04-2008, 04:44 PM
| #2 |
| Nobody   Join Date: Sep 2008 Location: Maine
Posts: 966
| drive shafts
I bought these: http://www3.towerhobbies.com/cgi-bin...?&I=LXJH85&P=Z and plan to do this: How to Pede sliders..Drive Shafts but, I'm just a newb, so there might be other options. |
|
| |
|
10-04-2008, 05:33 PM
| #3 |
| Rock Stacker Join Date: Sep 2007 Location: york, SC
Posts: 73
|
thank you so much cordwood!! that is exactly what i needed!!! thanks again! daleo |
|
| |
|
10-04-2008, 05:46 PM
| #4 |
| TEAM MODERATOR   Join Date: May 2004 Location: Tennessee
Posts: 10,855
|
You do know those are itty bitty Pede shafts right? They'll work for a 2.2 crawler just fine. They won't last 2 seconds in a super. Go with Revo shafts and forget about it.
|
|
| |
|
10-04-2008, 05:59 PM
| #5 |
| Nobody Join Date: Sep 2008 Location: Maine
Posts: 966
|
I guess that's why it says Newbie under my name...
|
|
| |
|
10-04-2008, 06:09 PM
| #6 | |
| TEAM MODERATOR Join Date: May 2004 Location: Tennessee
Posts: 10,855
| Quote:
 For a super,these are the only shafts to run.....http://www3.towerhobbies.com/cgi-bin...?&I=LXHFY1&P=M Lots of good info here as well.....Building a Maxx crawler | |
|
| |
|
10-04-2008, 06:44 PM
| #7 | |
| Nobody Join Date: Sep 2008 Location: Maine
Posts: 966
| Quote:
so you'd buy 3 pairs of those shafts so that you can cut them up and make 2 longer shafts? Or I guess you could buy 2 axle shafts, which would probably need to be shortened, and then swap the stub shaft out for a knuckle. | |
|
| |
 |
| |
Linear Mode
