ax10 spur/pinion

[tapped-out]

hey guy is every one running stock gearin? If not stock what tooth pinion/spur gear.

 

[binaryterror]

Im running stock gearing on a Integy 55T, I think its perfect, good wheel speed and good low end power. I have found my spur getting clogged with some plant debris...not sure how long its going to make it with all that mashing around, we will see.

 

[sharpe351]

I too am using stock gearing in the truck with a Crawler Brushless setup. I keep popping off the front driveshaft in certain situations. The truck absolutly creeps and I love that. I've already taken it up some pretty serious inclines and I like the gearing just the way it is, although I may actually make it deeper (smaller pinion and larger spur [12p-92s]) once I get the driveshaft problem fixed.

 

[scalerfreak]

im running stock gearing with a 65t, and it does great in my opinion, creeps and it has a ballance of low-end power and wheelspeed, great setup for me

 

[cwkoehler]

Im running a Crawlmaster with 14T 48P pinion (stock) and a 93T 48P spur. The Crawlmaster needs something bigger than 87T stock in order to clear tranny. Additionally, washers had to be installed between the tranny and bottom plate to raise the Crawlmaster off the floor. Setup appears to work great (not much testing yet but more to come)


cwkoehler

 

[dc2drifterx]

Im running a 90/14 with a 55 turn motor at the moment, still playing around to see what works best for me, but so far so good.

 

[crawls2thewalls]

happy with stock for now:

55t lathe by the way

 

[Skyjacker56]

stock with 50t lathe works great for me, the only thing i need is different electronics, im running wk esc and radio and servo