calikingcrawler
RCC Addict
OG SCX10: I'm looking for the length "eye to eye" of the front and rear uppers and lowers. Making my own links, have all I need but the measurements. If anyone can help it would be awesome.
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Scx 10 link lengths.
- Thread starter calikingcrawler
- Start date
2500hdon37s
I wanna be Dave
lowers are 115mm ETE
uppers have a 60mm link with off set rodend and the "Y" link connecter then a 6mm spacer between the Y connecter and where the 3-link connects to the axle, not sure what 4 link would be but with the axial truss id use the same leingth or 5mm shorther"thumbsup"
uppers have a 60mm link with off set rodend and the "Y" link connecter then a 6mm spacer between the Y connecter and where the 3-link connects to the axle, not sure what 4 link would be but with the axial truss id use the same leingth or 5mm shorther"thumbsup"
calikingcrawler
RCC Addict
So roughly 4 1/2 inches. I don't remember the front and rear being the same length, but I could be wrong, been drunk to many times since I owned the OG
champ7times
Pebble Pounder
this site has been posted in the scale site thread , but what does it have to do with calikingcrawler's question.
and your sig should be '' buy it SELL it start all over''
calikingcrawler
RCC Addict
He randomly posted that in a few threads. TEAM3SIX is better!!!!!!!!!!!!!!!!
ae racer
Rock Crawler
yeh i like 3six stuff better but kuatto's pull pal is pretty sweet.
What four link are you using? That would help a lot."thumbsup"
calikingcrawler
RCC Addict
Well I was thinking about using urs, unless I can find an axial one dirt cheap.
Really I am just worried about the lower link lengths so I can set WB the uppers I can adjust to whatever I use.
Really I am just worried about the lower link lengths so I can set WB the uppers I can adjust to whatever I use.
champ7times
Pebble Pounder
r2j 4 link truss for the win "thumbsup" actually i am installing it now:mrgreen:
The standard SCX10 lowers are 105mm center to center, or just the link length is 91mm. Not sure on the uppers, I use the hand Bros kit in front and my truss in the rear. But the kit came with 60mm links to use with the bent rod ends and three link "Y". Hope that helps some."thumbsup"
calikingcrawler
RCC Addict
It actually does. I just picked up another honcho body so I may go with those links now. I have a honcho now so I can get the lengths from it. But if I use the stock honcho 106mm lowers and ur upper mount what length uppers do I need. I run 106mm uppers on my honcho now with the axial mount.
Cableman
Quarry Creeper
The r2j mount uses the same links upper and lower "thumbsup"
I think the axial one is suppose to use shorter ones on the uppers
calikingcrawler
RCC Addict
The axial one actually works VERY well with the same length also.
Yep, uses same length as lowers."thumbsup"
