vp setup dig servo question

[scaleerdad]

i picked up a vp cassis with hurst vp dig axail axles and tranny my question is i have the standard size servo mount for the dig but a standard size servo wont fit in the chassis what servos with short casings you guys using for this type of setup

[DRV KRAWLER]

Originally Posted by scaleerdad

i picked up a vp cassis with hurst vp dig axail axles and tranny my question is i have the standard size servo mount for the dig but a standard size servo wont fit in the chassis what servos with short casings you guys using for this type of setup

Get the Mini servo mount from VP and buy a Hitec 225mg thats what I run for a servo on my "The official Tuolumne County Poison Dart"

[scaleerdad]

thank you i may have to do that because the savox servos are pretty damn expensive with short casings

[pigblanket]

I had a hard time on my wedge. Here the link to it. There are pictures of what I did in the link. I think a full size servo would fit also.

Bwd wedge