Re: Choosing a motor and ESC for your Wraith - Gearing Added! And it sound like I may heve been better of going with the 25T HH TM Pro motor. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
This guide gives guidance on motors. The first page has all the good info. I suggest no faster than a 27t brushed motor. If you want faster you need to go brushless. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Ok. I did that originaly and I am not happy with the results. My NOVAK TIMBUK2 wraith edition failed way too fast as for what it has been toated to be able to do! Ill try out the 21T and go from there. I'm mainly going to be bashing with it but maybe ill get a 27t TM or a 13T or 11T CM. Thanks again Harley for all the great info! Kinda frustrating but still verry cool hobby....cant wait till I know more about it. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! I am running a 55t with 80(robinson slipper unit)/ 18 gearing. Stock ESC/ 2s lipo and I still feel like it powers out. any suggestions?? I just want it to crawl anywhere I point without powering out. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! 3s lipo and gearing like I suggest on the first page. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Thanks Harley, So your thinking going up to an 84/18. Swap the ESC for one that can handle 3S and stay with a 55t brushed? I am new at this but learning a long the way. I have swapped out the entire front drive to all aluminum. I have beadlocks running tsl's with no foam, and 3oz of weight in the fronts 1 1/2oz in the rears. I need a new servo and was thinking of a castle BEC to run it. Any suggestions on a servo and is chassi mounting worth it? Hopefully I am the right track, i have a lot invested into this little buggie. Thanks again Harley, You have a huge following on here! |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Great thread.........only WAY to long! LOL I am running 32P 60/10 spur/pinion with the 27T Axial motor and want to upgrade the motor (I think.....) I am doing mainly crawling with some trail driving. So far I am liking the power/speed from this setup on a 2S. It is a bit slower than I want and am thinking about going to a 11 or 12 pinion when a bit more wheel speed is wanted. If I decide to upgrade the ECS/motor, which would be better ..... Holmes Hobby CrawlMaster Pro 13T w/ BRXL or Timbuk2 Wraith edition? I am not planning on a lot of water/mud driving but want to be sure that I could get it a bit wet when needed. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
Later Speed |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! If I put a 55t motor in my wraith with stock gearing would it be similar to a honcho with a 35t motor with stock gearing thanks |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
|
Re: Choosing a motor and ESC for your Wraith - Gearing Added! i havent read through this entire thread. its SUPER long! wanting a suggestion though. ill mainly be crawling, but want enough wheel speed for trails and climbing dirt hills. i saw you recommended the 13t crawlmaster, but how good will the 13t crawl? should i go 16? also, would you recommend 2s or 3s if it were yours? will also be using a cc bec for servo |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
|
I read the first page, I was just a little unclear I guess. Were the results in first page on 2s, 3s or what? Is the 13t on 3s enough to crawl really slow but still have the power to get some decent speed as well? I'm wanting to be able to crawl pretty well because that'll probably be what I'll do the most. I'm just torn between 13 and 16 because I have not used either |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
|
Harley, I ordered the crawlmaster combo a few days ago with a 13T motor. I did not ask for any timing to be added to the motor. Should I have? I'll be using my wraith as an all around rig (trail running, crawling some bashing). As there is a 2 week lead time I figure I still have time to request added timing. Thanks for all your write ups. Super helpful. Cheers. *Edit - reading through the HH Vendor section I found a tech article on timing the motor. Thanks anyway Harley. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! I'm sorry, I tried to sift through this thread and find my info. But I probably missed it. I definitely read the first page though "thumbsup" My buddy found a Motor/ESC combo that he wants to run. What kind of characteristics should we expect from Tekin FX-R 45T HD Combo? (Holmes Hobbies / Holmes Bikes :: Combos :: FXR Rock Crawler Combo 45t Pro) He's into crawling, so I suggested one of these, based on your posts on the first page: TorqueMaster Crawlmaster combo: Holmes Hobbies / Holmes Bikes :: Combos :: TorqueMaster Crawlmaster combo TorqueMaster Expert combo: Holmes Hobbies / Holmes Bikes :: Combos :: TorqueMaster Expert combo Do my suggestions come with adequate ESC's? I have been gathering different gears so that we can play around with our options, so we'll figure that part out 2nd. Thanks for any help you can give! |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
|
Re: Choosing a motor and ESC for your Wraith - Gearing Added! I'll pass on the info. Thanks for such a quick reply! Wonder if that ESC would work with this motor whenever it finally comes out... Holmes Hobbies / Holmes Bikes :: Motors :: Brushed :: Puller 540 Crawler TTC motor Not enough info to really be able to tell. |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! i run a 55t motor w stock gearing and i love it,,, goes up anything i want depending on traction,,, muddy hill climbs not so good, but rocks, dirt, water trail runs, 55t stock gearing perfect for me,,, |
Re: Choosing a motor and ESC for your Wraith - Gearing Added! Quote:
|
All times are GMT -6. The time now is 05:35 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com