|
| LinkBack | Thread Tools | Display Modes |
08-03-2014, 04:20 PM | #1 |
Pebble Pounder Join Date: May 2014 Location: Hartville
Posts: 101
| Axial cvd starting to get some play...replacement options?
So I spun the front locker in my wraith. As I was pulling them out I noticed the axial cvd's I've had for a while are starting to get some play. Should I just order another set or save up for the spendy vanquish cvd's |
Sponsored Links | |
08-03-2014, 04:28 PM | #2 |
Rock Crawler Join Date: Jul 2009 Location: Victoria Australia
Posts: 891
| Re: Axial cvd starting to get some play...replacement options?
From what I've been reading on here most people recommend the axial uni's over the vp cvd's so I would save your money, how much play/wear do they have.
|
08-03-2014, 04:35 PM | #3 |
Pebble Pounder Join Date: May 2014 Location: Hartville
Posts: 101
| Re: Axial cvd starting to get some play...replacement options?
Eh they're not falling apart but I don't like the play. Guess I'll run em
|
08-03-2014, 05:27 PM | #4 |
Rock Crawler Join Date: Jul 2009 Location: Victoria Australia
Posts: 891
| Re: Axial cvd starting to get some play...replacement options?
A bit of movement won't hurt anything. Just keep an eye on the wear. |
08-05-2014, 06:18 AM | #5 |
Pebble Pounder Join Date: May 2014 Location: fernandina beach
Posts: 111
| Re: Axial cvd starting to get some play...replacement options?
I have an old set of Axial cvd's just like yours and they take the power of a big brushless on 3s lipo just fine. I would invest in the Vanquish lockers though, they are a two piece design in which the inner locker rides inside the outer spool suspended on 2 O-rings. This design absorbs hard shocks to the axles and makes them last a bit longer. good luck, j
|
08-05-2014, 01:05 PM | #6 |
Quarry Creeper Join Date: Jul 2013 Location: Maple Ridge B.C. Canada
Posts: 330
| Re: Axial cvd starting to get some play...replacement options?
The lockers will make a big difference and you can also shim the cvd at the pin before you put your hex's on. I have found that helps a lot.
|
08-05-2014, 05:28 PM | #7 |
Pebble Pounder Join Date: May 2014 Location: Hartville
Posts: 101
| Re: Axial cvd starting to get some play...replacement options?
Well hopefully these last a while! I want another set for the rear when I add rear stear
|
Axial cvd starting to get some play...replacement options? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CVD axle shaft options on V3 CVD | RickM | Team Losi Comp Crawler | 2 | 10-26-2011 07:58 PM |
CVD options? | the_ghetto_rig | HPI Wheely King | 2 | 10-25-2011 10:05 AM |
Thank you FUNRISE! Replacement parts are starting to arrive!!!! | ColquittCustom405 | General Crawlers | 7 | 04-11-2006 04:58 PM |
| |