|
| LinkBack | Thread Tools | Display Modes |
01-30-2012, 10:15 AM | #1 |
RCC Addict Join Date: Dec 2011 Location: Raleign
Posts: 1,439
| LED voltage/resistor calculation
Ok, I think I wired it wrong now that I read a little. Please check this out: 5v 30ma LED RadioShack® 5mm LED (Blue) Model: 276-311 | Catalog #: 276-311 Anyway, I have it wired direct to the 5v on the power regulator and I'm thinking know I need a resistor in there to keep it from burning out. Some of the reviews said that I need to put in about a 68 ohm 1/8 watt resistor. So, do I need to stick a resistor in there or am I good? It's been years since I took e-sci. |
Sponsored Links | |
01-30-2012, 10:23 AM | #2 |
RCC Addict Join Date: Dec 2011 Location: Raleign
Posts: 1,439
| Re: LED voltage/resistor calculation
Cool, that helps. The only thing is the LED I purchased doesn't say what the voltage drop is. I guess I'll just get a mixed pack of resistors and give them a whirl. It definitely won't hurt to have too high a resistance (it just won't light up) but too low is bad.
|
01-30-2012, 10:26 AM | #3 | |
Quarry Creeper Join Date: Jul 2009 Location: Back from vacation!!!
Posts: 356
| Re: LED voltage/resistor calculation Quote:
Bookmarked!!! Thanks! | |
01-30-2012, 10:33 AM | #4 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Re: LED voltage/resistor calculation
If you are powering a LED with a forward voltage rating of 5v with 5v then you dont need a resistor.
|
01-30-2012, 11:27 AM | #5 |
RCC Addict Join Date: Dec 2011 Location: Raleign
Posts: 1,439
| Re: LED voltage/resistor calculation I thought the resistor was to limit current though. It's a 5-6v LED though and is nice and bright. I just don't want it burning out prematurely. Or, wasting too much juice and killing my battery.
|
01-30-2012, 11:46 AM | #6 |
Newbie Join Date: Jan 2012 Location: Etobicoke
Posts: 5
| Re: LED voltage/resistor calculation
for a 5 volt source and up to 30ma you want a resistor that is 166 ohms or greater. The higher the value of the resistor the lower the brightness. if you go lower resistance you will run brighter but probably blow the led very early. calculatios: 5 volts / .03 A= 166 ohm a 180 ohm is a standard value(value they make resistors at). using 180 will give you a current through the led of 5v/180= 27.7 ma now using a 180 ohm resistor you have to make sure the wattage (resistors are rated up to wattage they can handle) 5V^2 /180 ohm= .138 W so a standard quarter watt resistor will work fine for you. For the voltage drop, the issue would be if your led's had a higher drop then your voltage drop. in the case of blue led's there no more then 3.7 volts. The resistor in this case is acting as a current limiter as an led will draw as much current as it can get until the junction overheats. Last edited by nocfed; 01-30-2012 at 11:51 AM. Reason: additional info |
01-30-2012, 11:58 AM | #7 |
RCC Addict Join Date: Dec 2011 Location: Raleign
Posts: 1,439
| Re: LED voltage/resistor calculation
Thanks nocfed, that's exactly what I was looking for. I ended up picking up some 68 ohm resistors at lunch so I can run two in series and get 136 ohm which will equate to 36.7 ma which should be within tolerance but still nice and bright.
|
01-30-2012, 03:48 PM | #8 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Re: LED voltage/resistor calculation
Thats interesting because if you use this calculator it says that you would need a 1 ohm resistor so i figure there is no need... LED calculator for single LEDs |
LED voltage/resistor calculation - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LED voltage help. | stelerzman | Electronics | 12 | 09-06-2011 04:18 PM |
General Scale Calculation Question and 1/16th K5 dimensions | braq | Micro Scale Rigs | 0 | 04-18-2010 11:18 AM |
Another resistor ??? | 86 Iroc | Electronics | 3 | 12-22-2009 07:27 AM |
gear calculation question | romulus22 | General Crawlers | 7 | 09-06-2009 01:44 PM |
LED: on which side do you put the resistor? | schlabinski | Electronics | 5 | 03-20-2007 12:15 AM |
| |