| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-25-2018, 12:22 AM
| #1 |
| Newbie Join Date: Mar 2018 Location: US
Posts: 1
|  Servo wiring help needed
Hello all, I'm needing a little help with my servo swap in my new redcat rs10xt. I'm not sure where I need to plug in the font steer servo, and the rear steer servo on the receiver on the car itself. I thought they were removed from the 1and 4slots, but I am now not getting any rear steering. Front steering is plugged into slot 1 and works fine, throttle is in slot 2 and works forward and reverse fine, the binding loop is in slot 3 and the rear steering is plugged into the last slot 4.. do I have the rear steering and binding loop in the wrong slots ??? Thanks for any help in advance.
|
|  |
| Sponsored Links | |
| | |
|
Servo wiring help needed - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring nightmare - Harness needed? | Truckmechanic304 | Electronics | 6 | 11-10-2016 03:41 PM |
| Wiring advise needed | Abrown83 | Electronics | 3 | 11-09-2013 03:02 PM |
| servo wiring help! | holycaveman | Electronics | 4 | 02-28-2011 11:44 AM |
| Basic Wiring Diagram Needed | aggierc | EnRoute Berg | 1 | 10-15-2009 08:25 AM |
| |
Linear Mode
