![]() | #1 |
Newbie Join Date: Jan 2016 Location: Worcester
Posts: 32
| ![]()
Just about to start build and want to feed 7.4v direct into my savox 35kg hi servo. Problem is my rx I believe is only rated for 6v! Can just run positive and negative wire from servo into main Battery feed and the signal wire into the receiver steeringg channel? I also considered a cc bec but assume that would push 7.4v into receiver before going out to servo? Any advice appreciated |
![]() | ![]() |
Sponsored Links | |
![]() | #2 |
Quarry Creeper Join Date: Jun 2010 Location: lexington nc
Posts: 251
| ![]()
get a castle bec an programer u will b able to set the voltage as for wireing the bec tap into the batt plug an the to the pos an neg wire on servo the white wire goes to reciver what savox servo did ya get
|
![]() | ![]() |
![]() | #3 |
RCC Addict ![]() Join Date: Aug 2017 Location: Fredericksburg, VA
Posts: 1,824
| ![]()
Along with the Castle BEC you need the Holmes bypass adapter with will simplify your wiring. https://holmeshobbies.com/electronic...s-adapter.html Last edited by Inspector86; 12-29-2018 at 06:28 PM. |
![]() | ![]() |
![]() | #4 |
Newbie Join Date: Jan 2016 Location: Worcester
Posts: 32
| ![]()
sorry for the late reply, that's great info thanks
|
![]() | ![]() |
![]() | #5 | |
I wanna be Dave Join Date: May 2007 Location: Vancouver, BC
Posts: 2,317
| ![]() Quote:
This kind of restates what you wrote: Yes, another one: BEC to HV Servo Wiring | |
![]() | ![]() |
![]() |
![]() | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Buttery Smooth! Axial SCX10II Bleeded Shock Mod - A Must Do all SCX10II | joerc2013 | Axial SCX10 II | 58 | 07-13-2020 10:44 AM |
What electrics?? | tcm glx | Axial Wraith | 2 | 11-11-2012 04:53 PM |
different electrics | gaz | Electronics | 2 | 03-20-2012 07:41 PM |
where are your electrics? | crazee horse | Axial Wraith | 8 | 12-11-2011 02:34 AM |
No Electrics | cpower36 | HPI Wheely King | 1 | 02-22-2008 04:10 PM |
Thread Tools | |
Display Modes | |
| |