| |
07-04-2020, 06:00 PM
| #1 |
| Pebble Pounder Join Date: Oct 2010 Location: washington
Posts: 123
|  HW AXE weird problem
HW AXE 2300. After I run it for 10 min or so i can hear the motor cogging and my micro servos will have a hard time holding position. Then the esc will start switching from forward to reverse really fast about 5 times per second under full throttle, and then will just stay in reverse, even with the remote turned off. Only way to stop it is to turn the truck off. If i turn it back on i have no throttle at all. Also when this happens I get a constant double flashing green light. System is a month and a half old. Anyone else have an issue like this?
|
|  |
| Sponsored Links | |
| | |
|
07-04-2020, 07:15 PM
| #2 |
| RCC Addict Join Date: Jun 2008 Location: Mudville
Posts: 1,592
| Re: HW AXE weird problem
How old is the combo? Maybe a Older Firmware version in the ESC. Upgrading that may help. Have not ran my two AXE rigs quite enough to help any more atm. |
|
| |
 |
HW AXE weird problem - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Really weird problem | 83trekker83 | Traxxas TRX-4 | 6 | 11-28-2018 09:46 AM |
| Weird Problem | mycroft1855 | Redcat Crawlers | 6 | 03-04-2012 07:35 AM |
| Weird problem with my M8 | Mongo | Electronics | 2 | 08-09-2008 09:42 PM |
| Weird problem | MilesToEmpty | General Crawlers | 3 | 01-19-2006 08:52 PM |
| one really weird problem | ttrmike | Comments, Suggestions, and Help | 1 | 08-20-2005 11:20 AM |
| |
Linear Mode
