Just another Enduro

[Satan6907]

Been along time since I have posted here. Picked up the Enduro from rpp over black Friday.

Pulled it out of the box and started mods right away. First was the bumpers. Those stock bumper just hung out and down to far. Had a spare set of Cherokee bumpers laying around, so I had to try them, fit was great and I think they look alot better then the stockers.




Swapped out the servo for what I run in all my trail trucks, Turnigy mg959, well the bec in the stock esc was not going to handle this servo, so out went the esc and in went a sidewinder 4 and bec.

Did a few body mods also, 3d printed braces and moved the stock out further, really helped with the swat right at the cab and bed joint. Also rounded out the cutout for the sliders.



Installed stainless hardware. I always keep a stock of most m3 sizes. While I was at it, swapped in the optimal overdrive, first rig with overdrive.

Will keep the stock tires for now, but debating on rims. Got a set of the gearhead champs with the truck, but might go vp.

[JSterrett]

Originally Posted by Satan6907

.



Did a few body mods also, 3d printed braces and moved the stock out further, really helped with the swat right at the cab and bed joint. Also rounded out the cutout for the sliders.

I recognize those braces... lol

Sent from my SM-G970U using Tapatalk

[Satan6907]

Originally Posted by JSterrett

I recognize those braces... lol

Sent from my SM-G970U using Tapatalk

great file to print out and get some more rigidity from the body. I see you mounted them with the ear to the outside. The way I have it done helps the body sit right with the bumper.