03-31-2013, 06:22 PM | #1 |
Newbie Join Date: Jan 2013 Location: chico
Posts: 10
| slope in portal axles
is there anything that can get rid of the slop* in the axles? thanks
Last edited by 530_crawler; 03-31-2013 at 06:56 PM. |
Sponsored Links | |
03-31-2013, 06:54 PM | #2 |
Quarry Creeper Join Date: Jan 2012 Location: Bloomington
Posts: 371
| Re: slope in portal axles |
04-01-2013, 10:23 AM | #3 |
Quarry Creeper Join Date: Jun 2012 Location: Port Coquitlam, BC
Posts: 222
| Re: slope in portal axles
Probably talking about the "axial play" in the axle or "gear lash". I haven't had a chance to open it op the axial to see where the play is occurring. The only adjustment you can do to reduce the play would be the pinion to diff. You can adjust this by adding in shims on the pinion and in effect push the pinion further into the axle to tighten up the gear mesh here. For the rest of the axle, there isn't much more adjustment available. Check for worn parts and bearings. |
04-06-2013, 11:02 AM | #4 |
Newbie Join Date: Jan 2013 Location: chico
Posts: 10
| Re: slope in portal axles
i blew out most of the smaller bearings in the front axle
|
slope in portal axles - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rc4wd Portal Axles | Jersdunz | Tamiya TLT Crawlers | 7 | 05-05-2007 09:19 PM |
Portal Axles | MTUJeeper | General Crawlers | 18 | 12-26-2005 12:57 PM |
portal axles | Magic | Tamiya TLT Crawlers | 0 | 12-20-2004 01:16 PM |
| |