WB8 Drive Shaft Mod

[SCX10bgfn!]

Originally Posted by Hardline

Why access to the screw? Can't you just secure it with proper torque, loctite, etc and then stuff a solid rod down the center? I can't think of why I'd want to get back to that screw again unless the shaft failed and I want to salvage parts. In which case I can just cut the bad shaft off above the screw and now have access to it again. Or am I missing something?

I used CF rod and epoxy to beef up my Pede's. I would think that would work for the Wild Boars too.

BTW, I missed that new WB's are stronger than the original. How are they physically different?

I just used a solid rod and my driveshaft joint is about to fall off of the actual shaft and I can't do anything about it. Just gotta wait until it falls out before I can do anything...