05-26-2018, 09:21 AM | #1 |
Newbie Join Date: May 2017 Location: US
Posts: 4
| Wiring help needed
Hello everyone, So I am at the point finally to make my connections to my receiver. A little back story, I am running the dual mini esc' s with BEC from Holmes hobbies with HH motors. I have everything in place on my rig and I'm not quite sure how to make final connections without frying something. Just looking for a little guidance on the subject. I've looked at diagrams but those didn't help me much. Any help would be appreciated. Pictured below: Black wire - steering servo Large 3 color wire is bec Small 3 color wires are esc's Sent from my SM-G935V using Tapatalk |
Sponsored Links | |
06-05-2018, 07:06 PM | #2 |
Pebble Pounder Join Date: Feb 2017 Location: Canada
Posts: 104
| Re: Wiring help needed
oy where yall at? I'm just about to run my bully on two ESCs for the first time and the diagram I have says BAT: BEC chan1: servo chan2: esc1 chan3: chan4: esc2 This is an old diagram and I haven't personally plugged mine into a battery yet cuz im waiting on a radio. Im hoping someone with some know-how can confirm. Should be simple enough and I can't see anything getting fried from being in the wrong channel. |
Wiring help needed - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Servo wiring help needed | mrmotard | Electronics | 0 | 03-25-2018 12:22 AM |
Wiring nightmare - Harness needed? | Truckmechanic304 | Electronics | 6 | 11-10-2016 03:41 PM |
Wiring advise needed | Abrown83 | Electronics | 3 | 11-09-2013 03:02 PM |
Basic Wiring Diagram Needed | aggierc | EnRoute Berg | 1 | 10-15-2009 08:25 AM |
| |