|
| LinkBack | Thread Tools | Display Modes |
01-27-2012, 07:25 AM | #1 |
Newbie Join Date: Dec 2011 Location: USA
Posts: 41
| Aluminum Clod Axle Parts
We use to only have JPS Aluminum Axle tubes, C's and Knuckles. I see Integy is making some of this stuff. Is it any good? I there anybody else out there making this stuff? |
Sponsored Links | |
02-19-2012, 08:04 PM | #2 |
Quarry Creeper Join Date: Nov 2010 Location: Toronto Canada
Posts: 445
| Re: Aluminum Clod Axle Parts
I've got Integy parts on my clod (axle tubes, knuckles, locked gear sets, gear boxes) including the gear set with their spool, I haven't had any issues with the aluminum parts other than I couldn't use my CPE rear steer lockouts and had to make up some linkage to hold the knuckles. The gearset on the other hand would not mesh properly without adjustable motor mounts. I just switched back (to plastic) the aluminum gear that meshes with the pinions and all was good. I still have to install the gearboxes but they seem to be a direct copy of the original casting, not 100% sure though you never know with integy until you get it all put together if everything works proper.
|
Aluminum Clod Axle Parts - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Axle Aluminum Parts | Man of 5lay | Axial AX-10 Scorpion | 9 | 07-08-2011 04:18 PM |
Axial Aluminum Axle Parts | Matt.k | Axial AX-10 Scorpion | 43 | 10-23-2008 08:45 AM |
| |