yes

Any chance for universals in ax10 length too? Make a nice match to your conversion c-hubs or people converting to xr10 knuckles.

YES please.

But with the Wraith axles coming out... I will use my AX10 axles for smaller projects.

These would be awesome, especially for the older Broncos...

http://www.tirerack.com/images/wheel...st_d_ci3_l.jpg

bump this idea!!

Ahh Yeeaaaah!!!! "thumbsup"

23mm axel spacer two jame inside tire on and extend out far enough rnough to mount a dual on for super rock slid

You need to make a gangster tool set, blast little VP logos all over the grip 8)

Wow, that is completely unrecognizeable as a sentence...

WOW...epic!

Brass or stainless steel wheel hexs to fit a Berg with super 300's.

I think what he ment was a 23mm axle hex that could extend so that 4 wheels could be put on each axle. I mean sounds like a decent Idea if he could write better than my 5 year older sister.

Here is my idea my own series of rims 8):mrgreen:

How about 6mm outputs for your axial dig unit?

What about a dif cover for the new Wraith axles?

Duno if this was mentioned...but the Berg guys look like they need a new light
weight low profile T-Case housing to go with those Clover tubes...That would be
trick.

X2

http://img40.imageshack.us/img40/6025/diffcover.jpg

yes!

Good Idea Fa1rchild "thumbsup"

I'd be down for a set of top quality V.P. tools

dont think anyone has said it or even thought about it but make this http://www.rpphobby.com/ProductDetai...ctCode=RRP1542
and instead of making the outputs normal length, make one side longer so that it goes past the spur gear like this http://www.rccrawler.com/forum/showthread.php?t=120623

so instead of buying two things, its just one iten all together