MOA Dig Controller

[heyok]

Originally Posted by Bansh88

Looking at the pictures, it looks like the motor leads have clear plugs on them? So they dont "need" to be soldered on.
I have an XR10 on the way without a dig unit. Someone here reccomended you and this looks great.

Appreciate that someone recommended this.
I can assure you that soldering is required. The clear part you see is heat shrink.

[Jeepkid]

I'm stoked to run a dig switch again. I had dual esc's and can tell you guys out there that every time I had issue with an esc in the dual setup I'd fry bother esc's. my buddy had an esc fry with his dig switch and the dig switch survived. It might be the rigid relays or something, but it cheaper in the long run to have one esc and a dig switch Heyok all the way. I'm going to promote Heyok every time I'm asked the dual esc vs. esc dig switch setup.

[Vwfreak]

So when using this do you need to instal a 3 way switch to the remote ?

[heyok]

Originally Posted by Vwfreak

So when using this do you need to instal a 3 way switch to the remote ?

That's correct.

I make a controller that will work with a two position channel also:
MOA Dig Controller for Two Position Channel

[chris goudy]

is this available still? i sent you a pm about 2 weeks ago...life got expensive ,but im ready with cash in hand...im just not sure how to send an order atm. a link would be immediatly used. paypall ready,gotta give you some shipping info and i should be almost good to go. thanks in advance,hope to hear from you soon.

[heyok]

Originally Posted by chris goudy

is this available still? i sent you a pm about 2 weeks ago...life got expensive ,but im ready with cash in hand...im just not sure how to send an order atm. a link would be immediatly used. paypall ready,gotta give you some shipping info and i should be almost good to go. thanks in advance,hope to hear from you soon.

I will send you a PM and we will get started. I don't have that part on my web store, or I would send you there.

[toy4crawlin]

HI
I want to get my moa working on a dig controller,
i had bought the wantAmix, but it was so complicated and now as I read about DUAL ESC's using dig systems, the esc's fry up.
I would like a simple install dig switch to use on my berg with Dual Torque masters.
I have a DX3R tx, spectrum 3ch and 6ch rx.
PLease help get my moa going again with DIG,,
I should have kept my DIY relay dig switch, but I really liked the idea of more axle control using Dual esc's.

Do I use Dual rate or a Mix on a DX6i tx ?
link to how or Utube?

Thank You

[heyok]

Hi,

I think you are asking me if you can run two 35t motors from a Mamba Micro ESC. Sorry, I don't know. I think there is someone from Castle on the forum. Maybe he/she will see your post and be able to answer.
If yes, then my dig controller could work for you if you have a free three-position channel to use for dig.

Thanks,
Al