2.2 Sporty - AR60 Axles

[The Violator]

Originally Posted by brazwewn

Not sure I am following you. Do you mean it would permanently bend the nose and make it too short? If so, I am not too worried about it happening. The plastic is pretty thick at that spot. It might bend, but would bounce back. The body is just a hair over 12.5" though.

Wes

If it bends out of spec but bounces back it was still out of spec. I would call it if it was on my course.

[brazwewn]

Originally Posted by The Violator

If it bends out of spec but bounces back it was still out of spec. I would call it if it was on my course.

That doesnt make sense to me. Bodies bend in and out of spec all the time when you get them bound up. I've never heard anyone getting an out of spec for a bending body panel. I know I am not the first person to have a cut down nose. I guess it's a good thing I don't drive in your neck of the woods!

Wes

[isyeskeert]

Originally Posted by The Violator

If it bends out of spec but bounces back it was still out of spec. I would call it if it was on my course.

Ha! I get it, it's screw with someone day! Lexan bodies flex all over the place!

[brazwewn]

Got my new body all painted up. I am getting better with painting, but still no pro!

Wes

[isyeskeert]

Looks great! I am sure that it is legal!

[brazwewn]

Originally Posted by isyeskeert

Looks great! I am sure that it is legal!

Thanks, can't wait to test it out.

Wes

[Master Basher]

I don't understand why you would use the offset axle housing as opposed to the center one. Why did you do that? parts availability? You are putting unnecessary angles on your driveshafts, no?