| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
05-02-2020, 09:11 PM
| #21 |
| Quarry Creeper Join Date: Jun 2015 Location: Athol, Massachusetts
Posts: 386
|  Re: CC BEC Powering Motor Issue...
5v on my bec. Yes for a lower turn motor 4 to 5 volts on the lathe should work fine. I run my 35 turn around 8 volts.
|
|  |
| Sponsored Links | |
| | |
|
05-03-2020, 08:09 AM
| #22 | |
| Pebble Pounder Join Date: May 2017 Location: El Dorado Hills
Posts: 113
| Re: CC BEC Powering Motor Issue... Quote:
| |
|
| |
|
CC BEC Powering Motor Issue... - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bec issue | 1santaever | Electronics | 11 | 08-22-2015 09:32 PM |
| Is this a BEC issue? | Lex07 | Electronics | 4 | 11-11-2014 05:59 PM |
| What Holmes motor are powering your scaler? | Mighty1 | General Scale Talk | 6 | 12-18-2011 01:50 PM |
| BR-xl not powering motor | slowngreen | Electronics | 5 | 08-31-2010 03:06 PM |
| BEC install for powering servo question? | Wild Snapper | Electronics | 7 | 11-06-2008 11:27 PM |
| |
Linear Mode
