|
| LinkBack | Thread Tools | Display Modes |
09-22-2020, 01:44 PM | #1 |
Newbie Join Date: Sep 2020 Location: ROCHDALE
Posts: 2
| Hobbywing 1080 calibration issue
Hi all. I have an issue setting up my 1080,s on my Bully 2 I have 1 esc per motor. And am running an MT44 tx with 482 RX servo is run directly of ccBec. 1 esc has red wire removed. Both power on fine. Neutrals on TX are default. Front motor esc is in throttle rear motor in aux1. The Esc's both calibrate the neutral position but forward and reverse nothing happens when black button on esc is pressed at a total loss. Any advice is appreciated.
|
Sponsored Links | |
09-22-2020, 03:06 PM | #2 | |
I wanna be Dave Join Date: Jun 2016 Location: Deep in the Everglades
Posts: 5,818
| Re: Hobbywing 1080 calibration issue Quote:
Each ESC has to be calibrated to the throttle first. I found it easier to do both on one channel, then switch the second to your other channel. I had this issue with both the BRMD, and dual 1080’s Hang up and Drive | |
Hobbywing 1080 calibration issue - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hobbywing 1080 quirky issue | Fricker08 | Electronics | 4 | 08-08-2020 02:30 AM |
1080 hobbywing calibration | Welderman85 | Electronics | 22 | 03-08-2020 11:34 PM |
Hobbywing WP1080 Calibration issues!!!! | CherokeeJustin | Newbie General | 53 | 06-28-2019 03:14 PM |
Hobbywing 1080 issue? | jakehinds | Electronics | 5 | 03-25-2019 01:30 AM |
Hobbywing 1080 esc programming issue | CRAWLIN5150 | Electronics | 2 | 06-19-2018 11:05 AM |
| |