|
| LinkBack | Thread Tools | Display Modes |
06-16-2014, 07:10 PM | #1 |
Newbie Join Date: May 2014 Location: Tx
Posts: 2
| Beating a dead horse WRAITH
New to RCs. Recently picked up a poison spyder. I ran through 4 charges on 2s lipo batteries and killed the factory 20t motor. Recently replaced it with axial 20t motor. Mods: Vanquish titanium steering links Advance metal fab body Warn winch w/ wireless remote Scaler fab bumper Further on, I've killed the factory servo. I did some research and picked up a hitec 7954SH and a cc bec. Can somebody school me on wiring and setup for cc bec and 7954SH??? I'm running all factory electronics. I think I may be in over my head. Thanks in advance. |
Sponsored Links | |
06-16-2014, 07:18 PM | #2 |
I wanna be Dave Join Date: May 2007 Location: Fairfield ME
Posts: 3,886
| Re: Beating a dead horse WRAITH
You will find that 99% of you questions as a new member can be answered by looking at the stickies in the appropriate section. Definitive Radio, Power Wiring, BEC and Servo Threads-- RCC's Top Tech Threads! |
06-16-2014, 09:18 PM | #3 |
Quarry Creeper Join Date: Jun 2013 Location: South jersey
Posts: 265
| Re: Beating a dead horse WRAITH
The most simple way for you to wire the BEC in is to plug it into the empty slot on your reciever and pull the red pin out of the ESC plug. Solder the red and black wires to the positive and negative battery terminals on the ESC. As for the servo, unplug the stock one, open the trash can and insert it. Take your new one and reverse the procedure for installation of the new servo. Later on down the line you can get a castle link and program your stock ESC (yes it's a rebranded castle) and set your BEC voltage higher. Don't feel intimidated by these tasks, they are very simple.
|
06-17-2014, 06:01 AM | #4 |
Quarry Creeper Join Date: Mar 2014 Location: LI
Posts: 376
| Re: Beating a dead horse WRAITH
Like you I was skeptical of wiring the BEC. I never had done anything like it and was nervous to screw something up. It turned out to be one if the simplest things I have done to my wraith. Follow what was stated above and you should have no problems. Search YouTube for a visual. |
Beating a dead horse WRAITH - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Beating the dead BEC horse. Please help. | jrowles91 | Electronics | 18 | 04-11-2014 11:31 PM |
beating a horse! | Rootar | Chit Chat | 9 | 01-15-2012 06:35 AM |
Project Dead Horse | IceBox84 | Axial SCX-10 | 6 | 12-19-2011 06:07 AM |
Beating a dead horse... | dAng! XJ | Axial Wraith | 4 | 11-17-2011 03:26 PM |
beatin the dead horse again ( which servo) | TwistedCreations | Electronics | 9 | 01-04-2005 08:44 PM |
| |