![]() | #1 |
Pebble Pounder ![]() Join Date: Aug 2012 Location: Irvine
Posts: 180
| ![]()
Why does my Novak Brushless crawler forget its programming. Up in OR on a work trip and had thrown in my SCX and a Wraith. Went to run them this AM and the SCX won't program. Even reset the TX, tried to reprogram the ESC (attempted, wouldn't ever complete the process). Wraith had a different issue and wouldn't run either. Too cold (high 30's) to try and figure it out sitting on the back of my truck. So no crawling, just some posed shots I'll post up later. |
![]() | ![]() |
Sponsored Links | |
![]() | #2 |
Pebble Pounder ![]() Join Date: Aug 2012 Location: Irvine
Posts: 180
| ![]()
I'm tired of this happening. I added in a BEC, SCX ran with the Novak Goat system for 10 minutes or so then started glitching/running backwards/etc (pack was fully charged). Tried to reprogram today but its doing the same thing all over again and then won't re-program. Time to move to Holmes I suppose. |
![]() | ![]() |
![]() |
![]() | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Programming ESC | lcbsc | Axial Wraith | 1 | 06-25-2011 03:53 PM |
Tx programming | crawlHTX | Electronics | 11 | 06-25-2011 03:44 PM |
programming a servo | zookiguy | Electronics | 5 | 10-22-2009 05:04 PM |
programming.. | resetpunk | Electronics | 4 | 01-04-2009 08:30 PM |
FX-R programming? | TK421 | Electronics | 14 | 06-09-2008 07:43 PM |
| |