05-15-2013, 10:46 AM | #1 |
Pebble Pounder Join Date: Nov 2005 Location: south jersey
Posts: 136
| setup questions
I just updated my clod based crawler to lipos and now I'm having all kinds of problems. Previous setup was 7-cell 4800mah nimh, 2xmamba max esc's, integy 65t lathe's with 8t pinions, 2xSpecktrum S6030's and 40series losi crawlers. I started running a 3S lipo and now when I turn both axles the truck goes into convulsions! Also, I smoked the rear motor. It only happened once but I know its time to replace them. Why did it happen and how do I prevent it? My guess is I need a BEC, but have no idea how to wire it with my setup.
|
Sponsored Links | |
05-15-2013, 12:36 PM | #2 |
Pebble Pounder Join Date: Nov 2005 Location: south jersey
Posts: 136
| Re: setup questions Does this look right? Except the dig servo would be my second steering servo? Last edited by redneckracerx; 05-15-2013 at 12:37 PM. Reason: picture wouldnt show up |
setup questions - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CC-01 best motor setup questions | calikrawler | Tamiya XC/CC01 | 10 | 11-14-2010 09:49 AM |
Couple of CR-01 Setup Questions | disjaukifa | Tamiya CR-01 | 18 | 09-22-2010 09:50 PM |
Questions about setup | tas basher | HPI Wheely King | 1 | 08-13-2008 08:42 AM |
SW2 setup questions | bi_eep | Tamiya TLT Crawlers | 3 | 06-26-2006 05:52 PM |
New Tlt - setup and a few questions | CrawlinBob | Tamiya TLT Crawlers | 1 | 06-23-2005 09:55 PM |
| |