Hex Drivers?

[travis4380]

I use the losi one also and love them. I also have the eds driver bits for my drill and their well made also. I would spend a little more now instead of having to buy a replacement later.

[Erik D_lux]

Originally Posted by Jacksprogis

I've found that i get through EDS 2mm tips on a monthly basis , I do love them though .
Jack.

This is where I am at with my EDS tools. I use mine A LOT for sure but I mostly use them on AL screws so I dont think I am that hard on them. I think I have gone through 4 - 2mm tips in the last 2 years or so? I should probably go through them more often but I dont replace them as often as I should.

I like the EDS handle and would like to keep it. Sounds like the Losi tip is good? I think I will try to buy one and hopefully the tip will fit in the EDS handle.

What is the best TIP for a driver?